RSS Feed

‘garage door opener installation’ Category

  1. Garage Door Opener Installation In Few Easy Steps

    December 14, 2017 by aucuse66

     

    The process of garage door opener installation is usually uncomplicated, though producers and parts may vary. Given that these openers are normally mounted by the consumer, installation directions are clear. The parts can be easily assembled by a professional who has years of experience and training for better Flat Rock garage door opener installation.

    This process needs to just take a very little amount of time and your opener will certainly be totally operational.

    Set up the Opener

    Set out all components as the instructions suggest. Components are typically marked or might have lettered stickers. The primary step is to assemble the rail. Next you will attach it to the opener’s motor head. As soon as the opener has been totally set up, the final action is installation.

     

    Affix the Rail to the Header

    To perform this step, you will need an 8-foot ladder. Increase your garage and mark it at the highest point. Shut the garage door.

    At the website of the mark, measure up 2 inches. All-time low of the header bracket will be put right here, over the center of the door. Place the header bracket on at the second mark and safeguard it with two wooden lag bolts.

    With the motor end on the floor and the rail inside the header brace, align the opener setting up on the door. You will certainly should align the holes on the rail with the header bracket. Glide a clevis pin through the brace and rail to affix.

    Mount the Electric motor

    Area the ladder at the rear of the door tracks, in the facility. Location the motor on the ladder. Gradually, increase the garage door till it comes in contact with the door. As you remain to unlock, the motor setting up will be taken off the electric motor. When the door is completely open, position a 2×4 between the opener rail and the door.

    To do your garage door opener installation correct, you will certainly have to attach the wall mounts to the motor head into the ceiling stuffs. Using the directions and wall mounts given, attach them to the ceiling with lag screws. After affixing the wall mounts, raise the electric motor head and bolt it to the ceiling hangers.